#[doc = "IOMUXC"]
#[repr(C)]
pub struct RegisterBlock {
#[doc = "GPR0 General Purpose Register"]
pub GPR0: crate::RORegister<u32>,
#[doc = "GPR1 General Purpose Register"]
pub GPR1: crate::RORegister<u32>,
#[doc = "GPR2 General Purpose Register"]
pub GPR2: crate::RORegister<u32>,
#[doc = "GPR3 General Purpose Register"]
pub GPR3: crate::RWRegister<u32>,
}
#[doc = "GPR3 General Purpose Register"]
pub mod GPR3 {
#[doc = "Set to enable LPSR mode."]
pub mod LPSR_MODE_ENABLE {
pub const offset: u32 = 0;
pub const mask: u32 = 0x01 << offset;
pub mod R {}
pub mod W {}
pub mod RW {}
}
#[doc = "DCDC captured status clear"]
pub mod DCDC_STATUS_CAPT_CLR {
pub const offset: u32 = 1;
pub const mask: u32 = 0x01 << offset;
pub mod R {}
pub mod W {}
pub mod RW {}
}
#[doc = "POR_B pad control"]
pub mod POR_PULL_TYPE {
pub const offset: u32 = 2;
pub const mask: u32 = 0x03 << offset;
pub mod R {}
pub mod W {}
pub mod RW {}
}
#[doc = "DCDC_IN low voltage detect."]
pub mod DCDC_IN_LOW_VOL {
pub const offset: u32 = 16;
pub const mask: u32 = 0x01 << offset;
pub mod R {}
pub mod W {}
pub mod RW {}
}
#[doc = "DCDC output over current alert"]
pub mod DCDC_OVER_CUR {
pub const offset: u32 = 17;
pub const mask: u32 = 0x01 << offset;
pub mod R {}
pub mod W {}
pub mod RW {}
}
#[doc = "DCDC output over voltage alert"]
pub mod DCDC_OVER_VOL {
pub const offset: u32 = 18;
pub const mask: u32 = 0x01 << offset;
pub mod R {}
pub mod W {}
pub mod RW {}
}
#[doc = "DCDC status OK"]
pub mod DCDC_STS_DC_OK {
pub const offset: u32 = 19;
pub const mask: u32 = 0x01 << offset;
pub mod R {}
pub mod W {}
pub mod RW {}
}
}