Module CSICR18

Source
Expand description

CSI Control Register 18

Modulesยง

AHB_HPROT
Hprot value in AHB bus protocol.
BASEADDR_CHANGE_ERROR_IE
Base address change error interrupt enable signal.
BASEADDR_SWITCH_EN
When this bit is enabled, CSI DMA will switch the base address according to BASEADDR_SWITCH_SEL rather than atomically by DMA completed
BASEADDR_SWITCH_SEL
CSI 2 base addresses switching method. When using this bit, BASEADDR_SWITCH_EN is 1.
CSI_ENABLE
CSI global enable signal
DEINTERLACE_EN
This bit is used to select the output method When input is standard CCIR656 video.
DMA_FIELD1_DONE_IE
When in interlace mode, field 1 done interrupt enable.
FIELD0_DONE_IE
In interlace mode, fileld 0 means interrupt enabled.
LAST_DMA_REQ_SEL
Choosing the last DMA request condition.
MASK_OPTION
These bits used to choose the method to mask the CSI input.
PARALLEL24_EN
When input is parallel rgb888/yuv444 24bit, this bit can be enabled.
RGB888A_FORMAT_SEL
Output is 32-bit format.